Preformed Permanent Pavement Marking Tapes (Reflective Surface)

Introduction

Preformed Reflective Permanent Pavement Marking Tapes are a new type of road traffic marking that can be directly installed on roads. it combines flexible polymer,high-refractive glass beads, wear-resistant layers, substrates, release film, and other components.

Product Details

Product Tags

Product size reference chart

Product number Standard Length(m) Standard Width(cm) Thickness(mm) Weight(±10%) Conventional packaging Adhesive
L5010X 40M 5,10,15,20, within 100 customizable 1.3-1.8MM 2.2kg/sqm 300*300*300MM without adhesive backing
L5011X 40M 5,10,15,20, within 100 customizable 1.6-2.2MM 2.4kg/sqm 300*300*300MM with adhesive backing

Technical Indicators

Properties

Typical data

Unit

Test Methods

L50111

L50112

________

________

Color

white

yellow

________

________

Thickness

1.8

1.8

mm

GB/T 7125

Water resistance

pass

pass

________

GB/ T24717

Acid resistance

pass

pass

________

GB/T 24717

Wear-resistant

40

40

mg

GB/T24717

Retroreflection

>250; >500

>175; >300

mcd/m 2 /lux

GB/T24717

Minimum adhesion

25

25

N/25mm

GB/T24717

Anti-skid value

45

45

BPN

GB/T24717

Instructions

1. The pavement marking tape without adhesive backing is commonly used in special environments and special materials, using special glue, such as two-component AB glue, 502 glue, etc.
2. The products with adhesive backing can be divided into ground brush primer and ground primer without brush according to the usage:
Without brush primer on the ground: It can be directly applied to smooth and flat surfaces without applying primer when used indoors, on outer pavement, and on various walls of place such as workshops, exhibition halls, squares, safety islands of toll stations, where few vehicles run over, it only needs rip off the isolated paper on the back of the product and sticks it directly to the joint surface. And its life can be 5 years to the longest.
Brush primer on the ground: It should be applied with primer on uneven surfaces or walls(e.g., Pattex Contact Adhesive, Maxbond UL 1603HFR-HS). The amount of primer required depends on the smoothness of the bonding surface, approximately 1 kilogram per 3 to 5 square meters. Please refer to the construction instructions when using the primer.

  • Previous:
  • Next:

  • Write your message here and send it to us

    Professional technical engineer dedicated to guide you

    According to your actual needs, choose the most reasonable overall design and planning procedures