high flow filter cartridge

Introduction

Product Details

Product Tags

High flow filter cartridge

It has a 6 inch/152mm large diameter, and is coreless, single open-ended with an inside to outside flow pattern.

Thelarge diameter with big filter area insures to reduce the number of filter cartridges and the dimension of housing required .The long service life and high flow rate result in low investment and less manpower in many applications. 

Key Features

◇ Gradient pore structure;

◇ Up to 70m³/h flow rate per filter cartridge for water filtration;

◇ Inside to outside flow configuration all contaminates held within the single open ended filter;

◇ High surface area design provides excellent flow rates and extended service life while maintaining high particcleremoval efficiency;

◇ Coreless construction to minimize waste disposal;

◇ Available in 20″/508mm, 40″/1016mm and 60″/1524mm lengths;

Typical Applications

◇ Prefiltration of RO, Pretreatment of sea water desalination;

◇ Condensate water filtration, hot water recovery in power generation;

◇ API, solvents, and water filtration in BioPharm market;

◇ The filtration of bottled water, high Fructose, edible oil, soft drinks, and milk;

◇ Paints and coatings, Petrochemical, Refineries;

◇ Microelectronics, film, fiber and resin;

Material Construction

◇ Filter medium: PP, Glass fiber, PP melt blown

◇ Support/drainage: PP

◇ Core and cage: PP

◇ O-rings: see the cartridge list

◇ Seal method: melting

Operating Conditions

  Polypropylene Medium Glass Fiber Medium PP melt blown
Maximum working temperature 80°C 65°C 120°C
Maximum differetial pressure 3.4bar 80°C 1.03bar 65°C 3.4bar 120°C
Recommended change out differential pressure: 2.4bar 20°C

Key Specifications

◇ Removal rating: 1.0, 5.0, 10, 20, 50, 70, 100 (unit: μm)

◇ End caps: Glass filled PP

◇ Outer diameter: 6″/152mm

◇ Suggested maximum flow of water: 20″ 660LPM / 40″ 1300LPM / 60″ 1900LPM

Ordering informations

PPD–□–○–H–☆–△–♡

 

 

 

No.

Filter medium

No.

Removal rating (μm)

No.

Length

No.

Connector mode

P

PP

010

1.0

2

20”

N

Inner pressure

G

Glass fiber

050

5.0

4

40”

W

External pressure

R

PP melt blown

100

10

6

60”

 

 

 

 

200

20

 

 

 

 

500

50

 

 

No.

End caps

 

 

700

70

 

 

 

 

 

 

100H

100

 

 

 

 


  • Previous:
  • Next:

  • Write your message here and send it to us

    Professional technical engineer dedicated to guide you

    According to your actual needs, choose the most reasonable overall design and planning procedures