HDPE PE100 pipe grade

Introduction

Product Details

Product Tags

Product detail

High-density polyethylene (HDPE) 100S is an ideal material for PE100 pipe because not only its stability but also its economic value should be considered when choosing pipe laying.

Why choose HDPE 100S pipe grade?

1.From the performance of the comparison, the connection is very safe, because basically will take the way of hot melt, so there will be little joint water leakage problem.

2. Moreover, the low temperature resistance and high temperature resistance of this material are also relatively ideal, which can be used within the range of minus 60 degrees to 60 degrees. And the chemicals buried in the ground, in the soil, don’t affect it. And because of the insulator, so it is not easy to occur electrochemical corrosion problems.

3. This kind of pipe aging resistance is also good, the service life can reach more than 50 years. Even by the harsh environment, wind, rain and sun, will not be damaged. When construction, it is lighter than galvanized pipe, so it is easier to handle and much easier to install. The cost of installation is greatly reduced, and the installation can be taken in a variety of ways, such as drilling or welding, hot melt.

Specification

Producter code

HDPE     100S

Properties

Limits

Results

Density,g/cm3

0.947~0.951

0.950

Melt flow rate(190°C/5.00 kg)

g/10 min

0.20~0.26

0.23

Tensile yield stress,Mpa  ≥

20.0

23.3

Tensile Stress at Break,%  ≥

500

731

Charpy Notched Impact Strength (23℃),KJ/㎡  ≥

23

31

Oxidation induction time

(210℃,Al),min  ≥

40

65

volatile matter,mg/kg  ≤

300

208


  • Previous:
  • Next:

  • Write your message here and send it to us

    Professional technical engineer dedicated to guide you

    According to your actual needs, choose the most reasonable overall design and planning procedures