TD-5Z is our star centrifuge. It is very suitable to centrifuge 15ml,50ml and 100ml tube in low speed. For 15ml tube,it can centrifuge at most 32 tubes;For 50ml or 100ml tube,it can centrifuge at most 8 tubes. You can choose 48*2-7ml blood tube rotor if need to centrifuge vacuum blood collection tubes.

1.Variable frequency motor, micro-computer controls.

There are three kinds of motor-Brush motor, brushless motor and variable frequency motor, the last one is the best. It is low failure rate, eco-friendly, maintenance-free and good performance. Its good performance makes the speed accuracy reach up to ±10rpm.

2.All steel body and 304SS chamber.

For ensuring safe operation and making the centrifuge be strong and durable, we adopt high cost material steel and 304 stainless steel.

3.Electronic safety door lock, controlled by independent motor.

When the centrifuge is under operation, we must make sure the door will not open.We use electronic door lock, and use an independent motor to control it.

4.RCF can be set directly.

If we know the Relative Centrifugal Force before operation, we can set RCF directly, no need to convert between RPM and RCF.

5.Can reset parameters under operation.

Sometimes we need to reset parameters such as speed, RCF and time when the centrifuge is under operation, and we don’t want to stop, we can reset parameters directly, no need to stop, just use your finger to change those numbers.

6.10 levels of acceleration and deceleration rate.

How the function works? Set an example, we set speed 5000rpm and press the button START, then the centrifuge will speed up from 0rpm to 5000rpm. From 0rpm to 5000rpm, can we make it take less time or more time, in other words, run faster or slower? Yes, this centrifuge support.

7.Automatic fault diagnosis.

When fault appears, the centrifuge will automatic diagnose and display the ERROR CODE in the screen, then you will know what’s the fault.

8.Can store 100 programs.

In daily usage, we may need to set different parameters for different purpose, we can store those setting parameters as operation programs. Next time, we just need to choose the right program and then start.